Pages

▼

Saturday, September 2, 2017

Audio-Technica ATH-A2000Z (over-ear headphones)

Measurements

Audio-Technica ART Monitor ATH-A2000Z

• 53 mm dynamic driver
• adopted D.A.D.S (Double Air Damping System)
• Titanium housing


Audio-Technica ATH-A2000Z measurements

Check the Measurement Procedures first.

[1. Frequency Response ]
Uncompensated
(Averaged 5 Plots)

Diffuse Field Target Compensated

Harman Target Compensated

CSD - Diffuse Field Target Compensated


[2. Square Wave ]
30 Hz

300 Hz


[3. Minimum Phase ]


[4. Harmonic Distortion ]
94 dB SPL @ 500 Hz


[5. Impedance Magnitude ]
Black: Impedance Magnitude
Green: Electrical Phase




at

3 comments:

  1. AnonymousSeptember 13, 2017 at 12:04 PM

    Nice, I enjoy seeing full sized headphones being measured :)

    ReplyDelete
  2. UnknownJune 20, 2020 at 9:18 AM

    hello, thank you for your work. i have one thing i was wondering, could i apply an EQ correction to the master channel of my music production software in order to obtain a flatter response based on your measurement? i have Sonarworks reference but this model of headphones is not supported. thank you

    ReplyDelete
    Replies
    1. SpeakerphoneJuly 24, 2020 at 3:14 PM

      Of course you can, but I do not recommend that because the peak and deep of the frequency response are too narrow so that would not work well for this pair.

      Delete